Thrustmaster Flt Control System

[Sokol1]

Originally Posted by bolox

You have Elite pedals , correct? (and yes they are rather nice)
AFAIK they will only connect to specific Thrustmaster HOTAS, eg Cougar.

The wiring of the pot may also be problematic if you try to attach to a Bodnar board (or similar) as it uses a 2 wire system, rather than a 3 wire 'voltage divider' circuit used by these.

The pedal linked in Craiglist is the Tm RCS, prior of Tm Elite.

I dont find problem to wire one in modern USB controller, just is not "PnP".
As noted is need use 3 wires instead 2, and I did it using original cable:



The cable external shield net is now GND wire.
The pot in picture is original Tm - later replaced by a HALL Sensor.

In this small box fit the new USB controller - a DIY Mjoy8.



To interface the USB box with computer use a ordinary USB A/B printer cable.

A similar approach can be done with BU0836 or similar.

BTW - In the original form this pedal have only one axis, no brakes axis.

Sokol1