![]() |
|
Controls threads Everything about controls in CoD |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
No I didnt, what does that do exactly
|
#2
|
||||
|
||||
![]()
Ok then, open the control manager and open the control center. Load that .map you have/select "direct" mode on the tool bar/select "calibrate" on the tool bar/calibrate your equipment/select "mapped mode" on the toolbar/press download...windows will then load the drivers
![]()
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5 |
#3
|
|||
|
|||
![]()
You are going to have to go into IL2 ClOD itself to assign to correct axis i.e. stick to elevator and aileron etc.
Il2 might automatically attempt to map them, but as you noticed, it may not get it right. |
#4
|
||||
|
||||
![]() Quote:
CoD seems to "remember" my different throttle and joystick axis on my HOTAS, but frequently mixes up the axis assignments on my CH Pedals and CH Quadrant -- usually after a PC reboot. It's a slight nuisance, but I've gotten used to quickly going into the ingame Options/Controls/Axis GUI to quickly reassign these errant axis. It literally takes me 30 seconds to run through each one and hit "Apply" before returning to the game. Very strange.
__________________
|
#5
|
||||
|
||||
![]() Quote:
![]() Quote:
![]()
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5 |
#6
|
||||
|
||||
![]()
Ahhh, that must be it. CoD is the first Steam game/sim I've had, so there's another life's mystery solved. Thanks, SB!
__________________
|
![]() |
|
|