Re-Installing from CE Disc?

VO101_Tom · #1 02-01-2012, 04:36 PM

Quote:

Originally Posted by SEE

The game has gone into slow motion and the sound has become a mess - Engines are a awful drone, character voices are slow,distorted and jumbled in with the monotonic sound of what is supposed to be the engine. There is a two second lag from my Stick inputs and it takes about 20 seconds for the game to render at the start of a mission.

I don't think its a hardware problem as IL946 maxed out using missions on Cannons Map play perfectly well and uses 1.6Gb of Vram.

1946? That's a 10 year old game, a totally different level of details, and system requirements.

Sadly, I think this is a CPU performance issue. Two member of my squad had similar problem (input lag), the only workable solution was the PC upgrade (they didn't want to wait till the next patch).
What you can do, pull down the graphic settings: the epilepsy filter, ssao, trees and land shaders. It this is not help, you have to wait till the next patch (performance gains promised).

SEE · #2 02-01-2012, 04:49 PM

Its been fine, this has suddenly started today.

5./JG27.Farber · #3 02-01-2012, 05:31 PM

Right click the game in steam library and delete local content. Delete the folder in Steam/apps/common for the game.

Delete the folder in documents - 1csoftclub.

Use a problem Like like Ccleaner - its free!

reinstall via steam and or disc.

Give that ago. NOW, before you put your folders back in the game, run it and see if everything is ok. This will isolate them from the problem solving. If all is well you can put your files back in.

SEE · #4 02-01-2012, 05:43 PM

Many thanks, I wasn't sure wether to delete CLoD using control Panel or using Steam. Will give it a go!

5./JG27.Farber · #5 02-01-2012, 11:39 PM

Hope this solves your problem, Please PM me if it doesnt, we will get it fixed.

You can delete a Steam game using any method.

SEE · #6 02-02-2012, 07:29 AM

It's not the game! The fault seems to be hardware or BIOS related, possibly the new GFX card.

After exiting Windows (but not switching the PSU off) and then later boot my PC, the moniotor does not display anything. I doubt its the GFX driver because it isn't active untill Windows loads. If I do a soft re-set the display works during the re- boot but CloD runs very badly and the sound is a total mess.

But, if I exit windows -switch the PSU Off then re-boot its fine and CloD runs perfect. It's happened a few times now......

5./JG27.Farber · #7 02-02-2012, 08:25 AM

Have you checked all cables are plug in properly.