I recall some discussion on the CH forums eons ago about CH calibration. they ade it quite clear that if you intend using CH manager then don't ever calibrate directly in Windows. (It was in the time of XP mind you). A utility exists to delete the windows calibration.
I have been using CH and CH manager for years with zero issues. Having been down the Cougar trail ..Uber next mods etc I switched to CH and never looked back. The stick and throttle are at least 4 years old and never missed a beat, or spiked or reduced sensitivity.
Only changes I have made are the Ivankuturkokoffrubberband mod. A 5 min job that allows you vary spring pressure in each axis independently as the only fault imo in the CH stick is its a little to light. With this my elevator pressure is about 1/3 more than Roll pressure which i have about twice as stiff as stock anyway. The mod is "Fail passive" and I get about 6 months out of a set of bands.
|
11-28-2011, 08:41 PM
Threaded Mode