![]() |
|
IL-2 Sturmovik: Cliffs of Dover Latest instalment in the acclaimed IL-2 Sturmovik series from award-winning developer Maddox Games. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Snapper, listen to me.
My sli setup works better than your. 1920x1080px 120HZ with very high settings and a single gtx 470 run quite smooth (50-60 fps). Then I enable sli, I can see sli working (very bad, like you) on my monitoring software, and a lot of stuttering makes me angry because I can see a little fps increase but all that stuttering makes my game unplayble, nooOOOO...BUT just with this settings! I have no stuttering problem with your resolution and settings with sli enabled, because sli with that resolution and settings is useless...right?! Snapper can you hear me!? SLI is not working properly! Snapper!SNAPPER! |
#2
|
||||
|
||||
![]()
I'll switch back over to my 2nd monitor which gives me 1920 x 1080 res (at 60 Hz though) and take another look. In the recent past I've run CoD on this second monitor in SLI mode and was pleased with how well it ran, too. The only setting I have turned down as you can see is "textures" -set to "high" instead of "original".
As I've mentioned earlier, CoD runs very well for me in SLI mode with little-to-no stuttering. I believe it could run even better if 1C released a SLI profile specifically tuned to Cliffs of Dover.
__________________
|
#3
|
|||
|
|||
![]() Quote:
|
#4
|
||||
|
||||
![]()
Not yet!
![]() I was planning to do it last night (it only takes a minute or two to switch monitor assignments in the Nvidia Control Panel). Instead, I had the brilliant idea to first try the beta 285.27 driver and completely mucked up my PC. (I've whined about it on another thread). By the time Windows Restore & Disk Repair put things right, it was quite late so I just did a quick check with CoD on the lower res monitor, restarted my heart, and shut her down. ![]() Hopefully tonight I can give it a try when I'm back at my PC. Will keep you posted.
__________________
|
![]() |
|
|