Fulqrum Publishing Home   |   Register   |   Today Posts   |   Members   |   UserCP   |   Calendar   |   Search   |   FAQ

Go Back   Official Fulqrum Publishing forum > Fulqrum Publishing > IL-2 Sturmovik

IL-2 Sturmovik The famous combat flight simulator.

Reply
 
Thread Tools Display Modes
  #1  
Old 05-31-2011, 02:33 PM
FS~Phat FS~Phat is offline
Approved Member
 
Join Date: Dec 2010
Posts: 609
Default

The ultimate gaming rig has had another upgrade while I wait for COD to get sorted!
Installed an Aquaero 5 XT controller with 6 slave controllers and a bunch of sensors.

Have to say this was the most fun I have had playing with water cooling!!
I have setup "target temp" controls to adjust the various fans based on each loops water temp. Also for the internal air temp, and Fan Amp temps.
Running up on the bench to work out the configuration.

I have the RGB led installed replacing the Power led so I get another quick visual clue to whats going on. Green for below operating temp, blue for normal temp and red for overheating.







Remounting the waterblock with METAL screws and insulators to tighten up the mount. The included plastic screws felt too flimsy and left the block a little floppy.






Tidying up the cables.








The Aquaero loop temp sensors and CPU sensor installation.








Installed the PA2s with an old Ram fan to cool PA2 heatsinks. Works remarkably well dropping Poweramp temps by 20c! Of course controlled by a PA2, to ramp up with a target temp 70c with a virtual sensor i set up for the PA2 Fan Amp temps




Last edited by FS~Phat; 05-31-2011 at 02:39 PM.
Reply With Quote
  #2  
Old 05-31-2011, 02:35 PM
FS~Phat FS~Phat is offline
Approved Member
 
Join Date: Dec 2010
Posts: 609
Default

All Assembled







Overview page of my config in Aquasuite 2012.
A couple of the fans generate a dirty RPM signal below 6v but it doesnt effect the operation as the fans are voltage controlled anyway.



Settings screens







Aquaero screenshots













I did some reconfiguring today.
Ive loaded the 4 D5 pumps onto the controllers and they work a treat!
I have the following config now:

A5
Ch1 PA2 Fans
Ch2 D5-1 GPU Loop
Ch3 Exhaust Fans
Ch4 D5-2 GPU Loop

PA2's
Ch5 CPU Rad1 Fans
Ch6 CPU Rad2 Fans
Ch7 GPU Rad1 Fans
Ch8 GPU Rad2 Fans
Ch9 D5-1 CPU Loop
Ch10 D5-2 CPU Loop

Flowmeter 1 CPU Loop
Flowmeter 8 GPU Loop

Temp Sensors
T15 Ambient Air Temp
T13 Rad Air In Temp
T7 Internal Air Temp
T14 Rad Air Out Temp

T1 CPU Water in
T2 CPU Water out
T3 CPU Water Res out
T4 GPU Water in
T5 GPU Water out
T6 GPU Water Res out
T8 CPU Temp
T16 GPU Temp

Here's a 15min Furmark run with 15min cooldown.
What an amazing piece of technology!
Reallllly quiet for normal computing and light gaming, but an absolute powerhouse when required. All seamlessly controlled.






Last edited by FS~Phat; 05-31-2011 at 02:37 PM.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 02:12 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 2007 Fulqrum Publishing. All rights reserved.