Cant board ennemy tank

[Zeke Wolff]

If you want to capture enemy tanks, you must knock out the turret. If you go for the hull, the tank is a wreck in most cases (but not always). If the turret gets blown off, then the tank can´t be re-used.

Do you use any other mods except for DCG (ie running other mods at the same time as DCG)? DCG make any changes to when and if you can board a enemy vehicle, it uses the exact same routines for this as the vanilla SP MoW does.

I´ve played DCG for a very long time now, and I do not have any problems to enter enemy vehicles that I´ve forced the enemy crew to leave (by taking out the turret).

~Zeke.

[jocan2003]

I managed to get 2 tank after many hour of playing its easy yet not always, i mean taking out a turret you got to be lucky not to over do it and sometime the fifrepower is not enough, i tried with a 37mm US AT from the back of the turret its how i got it but heavy tank isnt doable for me, well thank for info

[Nokturnal]

You could just try to take out the treads, if the enemy is far enough into your territory they may abandon the vehicle as it becomes a sitting duck when immobile.

In the Battle of Vernon, i captured atleast 3 enemy tanks by doing this. Though i will agree that destroying the turret is the most reliable, and safest. But you don't really need luck, just good aiming, are you using direct-control mode?

[jocan2003]

When i want to capture yes and i would say 90% of the tmie im fighting tanks yes i do, sometime im just too busy somewhere else, and i dont play the campaign only the DCG right now