|
|
|||||||
| Controls threads Everything about controls in CoD |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-23-2012, 12:14 PM
|
|||
|
|||
is someone able to send me their profile so i can see if that works
|
|
#2
02-23-2012, 12:44 PM
|
||||
|
||||
|
Did you install the control manager software?
__________________
 GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5
|
|
#3
02-23-2012, 01:06 PM
|
|||
|
|||
|
Yes, I downloaded the raven profile uploaded on ch-hanger. When i load it in the manager then launch the game the throttle seems to over take the joystick. pitch and roll go to the mini stick on the throttle
|
|
#4
02-23-2012, 01:09 PM
|
||||
|
||||
|
When you opened the manager did you press the download button to CM control center?
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5
|
|
#5
02-23-2012, 01:15 PM
|
|||
|
|||
|
No I didnt, what does that do exactly
|
|
#6
02-23-2012, 01:25 PM
|
||||
|
||||
|
Ok then, open the control manager and open the control center. Load that .map you have/select "direct" mode on the tool bar/select "calibrate" on the tool bar/calibrate your equipment/select "mapped mode" on the toolbar/press download...windows will then load the drivers
__________________
GigaByteBoard...64bit...FX 4300 3.8, G. Skill sniper 1866 32GB, EVGA GTX 660 ti 3gb, Raptor 64mb cache, Planar 120Hz 2ms, CH controls, Tir5
|
|
#7
02-23-2012, 05:09 PM
|
|||
|
|||
|
You are going to have to go into IL2 ClOD itself to assign to correct axis i.e. stick to elevator and aileron etc.
Il2 might automatically attempt to map them, but as you noticed, it may not get it right.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
