It's worth checking the connector, as the cards usually run fine in 2d (the card gets plenty of power from the AGP slot to run with no load) then crash under 3D load when they're not getting power. Another thing you might want to do is check the bios to make sure your AGP settings are kosher for your new card. I know I'm going over the obvious stuff, but (at least for me) it's usually the obvious stuff that gets missed. I would also suspect that something might not be getting cleaned up with the drivers, although I can't offer any help there.
You might want to post over at UBI's tech forum, there are some clever guys over there. (more cleverer then me anyways)
Last edited by BadAim; 02-23-2008 at 05:24 PM.
|
02-23-2008, 05:22 PM
Threaded Mode