|
|
|
|
#1
12-30-2011, 11:50 PM
|
|||
|
|||
Weird trim response
I've assigned my three axes trim controls to the levers on a saitek throttle quadrant, problem is that if I adjust a slider slightly, the game just keeps the input going until the aircraft is fully trimmed to that side. It's like it reads the input as a button rather than an axis. Does axes input actually work for the trim controls?
Last edited by ush; 12-31-2011 at 12:05 AM. 
|
|
#4
01-01-2012, 12:38 AM
|
|||
|
|||
|
It works for me if I assign it to the rotary pot under left thumb of x52... Slider never tried yet...
__________________
 Asus P6T V2 Deluxe, I7 930, 3x2 GB RAM XMS3 Corsair1333 Mhz, Nvidia Leadtek GTX 470, Acer 1260p screen projector, Track IR 4 OS ver5, Saitek Pro Flight Rudder, Saitek X52, Win 7 x64 ultimate
|
|
#5
01-01-2012, 04:50 AM
|
|||
|
|||
|
The problem is he is using a throttle quadrant not a x-52 throttle. And Yeah Ush you should be able to set up all three as an axis. Have you messed with the dead zones at all?(at the bottom) It sounds like the quad is working but the game isn't seeing it as a axis. Did you go into your control panel and calibrate the quad? I use the CH quad and I have not had that problem. I guess the saitek quad is about the same set up only 3 levers instead of 6. If I can think of anything else, I'll post it.
|
|
#6
01-01-2012, 05:02 AM
|
|||
|
|||
|
Either its not seeing it as a axis or it is but the quad sliders are out of whack. Try unplugging them,plugging them back in and calibrate it. That's all I got for now. Its New Years time for beer. S!
And 79 you still need that X-52? http://forum.1cpublishing.eu/showthr...t=28497&page=2 Last edited by tf_Logan; 01-01-2012 at 05:04 AM. Reason: no reason
|
 |
|
|
Hybrid Mode
