I'm working on providing some tracks but have new information.
Please read carefully as I believe there is a new problem. But assume this is a "chapter two" of the previous post located here:
http://forum.1cpublishing.eu/showpos...7&postcount=78
I was very careful in this testing.
With the 16x20 Bomblets... the second set of train bombs released wtihout any input from either player.
It's just WEIRD. There is a track attached with commentary.
Player1 = Host / Bombardier
Player2 = Pilot
Connection: LAN. No I mean it. Literally two computers within feet from each other.
Start of mission, Player2 engages level autopilot. (also tested with the player just turning over control to copilot)
Player1 gets in CO-PILOT seat.
Player2 hands CO-PILOT control (full) to Player1. Player one sets up the plane for a successful bomb run.
Player2 engages level autopilot.
Player1 takes back full control of the airplane (but does not touch anything
FOR THE REMAINDER OF THE TEST).
Player2 gets in bombardier position.
Assume Player2 configures sight correctly.
Player2 configures salvo, 8 bombs (half), 500ms delay.
Player2 adjusts course by commanding C1 Autopilot and correct controls.
Player2 opens bomb bay doors.
Player2 enables Bomb Automation.
Scenario CONSTANT:
8 racks seem to release correctly (different result from previous testing where NOTHING was released given the same circumstances).
Now, the following two variations happen over 8 tests... EITHER
Scenario Variation 1:
Player2 then directs the plane with Turn Left/Right control to second target.
Assume Player2 configures sight correctly.
Player2 configures salvo, 8 bombs (the rest or "all"), 500ms delay.
C1 Autopilot is still on from first run; bomb bay doors are still open.
Player2 enables Bomb Automation.
Bombs Away appears as a message on the screen.
But bombs do NOT release.
Scenario Variation 2:
Player2 sits and enjoys first bomb run and the second set of 8 bombs mysteriously just DROPS for no reason about 15 seconds later.
Um...
Attached is the NTRK.