Quote:
Originally Posted by sg1221
You should just not worry about your Saitek sst program for now , just go
into the game and use the setup screens there . after you get it all set up
and get used to it in game you might wish to have some more advanced
controls and macros which you can use the Saitek software for.
The Saitek x 52 has lots and lots of buttons and axes so you'll probably
never have to use the sst software.
good luck and happy flying
|
+1
No need to use the programing software.
There are axes and buttons that do the same because you can set up an axis OR a key for a certain command. that is because some people do have joysticks with a lot of axes, where as others may only have 2-3.
As for the basic layout: i don´t have one, but i put everything concerning engine management on the left hand, weapons, etc. is on the right hand.
I don´t think there is a dumbed down manual, but the best manual that i know is getting on teamspeak and ask people. If that is possible, do it! Jump on the ATAG-TS, and you will get the help you need.
And btw. I´d much rather ask questions on the ATAG forum than over here... This forum is just slowly dying I think...
Good Luck!