Thread: Horton
View Single Post
  #175  
Old 06-15-2012, 01:55 AM
ACE-OF-ACES's Avatar
ACE-OF-ACES ACE-OF-ACES is offline
Approved Member
 
Join Date: May 2010
Location: NM
Posts: 2,248
Default

And I might as well repost these for readers to access....

Quote:
Originally Posted by STORMBIRDS
it is true (as some writers seem intent on repeating loudly and often) that the Me 262s swept wing design was due to the need to adjust the center of gravity for the aircraft
Quote:
Originally Posted by Dennis R Jenkins
The third prototype was the first Me 262 to fly on jet power alone, taking off on 18 July 1942 with two pre-production Jumo 004A-0 engines. The 12-minute flight reached an altitude of just over 6,000 feet and a speed of 375 mph. A second flight later the same day lasted 13 minutes and reached 11,000 feet and 450 mph. One problem that was immediately evident was that, in a bank, the airflow broke away early from the wing center section. A small fillet was added between the fuselage and engine nacelle, increasing the root chord and continuing the leading-edge sweep angle of the outer panels across the entire center section. This completed the change necessary to give the appearance of a truly swept wing.
Note not my opinion.. Just agreeing with what they said
__________________
Theres a reason for instrumenting a plane for test..
That being a pilots's 'perception' of what is going on can be very different from what is 'actually' going on.

Last edited by ACE-OF-ACES; 06-15-2012 at 01:58 AM.