One other thing I did do was after reading a post on Sli at one of the sites (I think it was Nvidia Sli Club) was to bring my clocks back to Stock. I am running factory O/C cards and there was an article that suggested to try to de-tune cards back to stock for better Sli performance. After I did that I have noticed a slight improvement. Also with "Nvidia Inspector" once you have your profile set try leaving it running but minimised while running COD. Although my cards are from different stables and have different clock settings I always use EVGA "Precision" to sync the two cards to exactly the same clocks. Also in Inspector unlock 'Mim" and "Max" in the O/C section. I go throuh this sequence each time to make sure the settings haven't reverted to factory. Make sure with "Inspector " settings that you have the right profile set and click "Apply Changes" each time, I have found that if I'm not careful when scolling down that I have changed the profile selection.
|