ACE-OF-ACES,
Quote:
Originally Posted by ACE-OF-ACES
I can not remember if Leo added the filtering or if it was a standard feature on the PIC controller he uses.. I got all my notes on it at work and I am at home today so if needed I could look it up on Monday
|
That would be nice...
Quote:
Originally Posted by ACE-OF-ACES
EDIT I looked up that A1302KUA-T.. it is a IC package that has an analog out so yeah that would work as an input to the BU0836.. But I think you will still need to read/count/monitor the pulses? Do you know if this is that the HALL sensor used in the G940?
|
About the G940 I do not know...
I checked Leo's site again (it's still disabled) and found a comment of him in some other forum (mentioned in an earlier poste here): His employee left him, he's on a project, so he won't take orders he's not able to process speedely enough...
Anyway: In *his* forum he once gave instructions for the A1302KUA-T:
Quote:
The connections are:
BU0836 GND === Hall sensor "-"
BU0836 +5V === Hall sensor "+"
BU0836 INPUT === Hall sensor "O" (output)
Just make sure you follow Hall sensor pinout carefully. It's a semiconductor device and could be damaged if not connected as designed.
|
and the two illustrating pictures from that post
Artist