random game crash
 

Hi there
I have il2 1946 4.101m and the game crashes sometimes. The picture freezes and there are like small squares on the screen and after a while it goes to black. The sound goes on. I have to hard reset the computer.
I have winXP prof
ATI Radeon HD 4870 (catalist 11.9 - the last one)
Intel Core Due E8400
2GB ram
onboard sound card on Gigabyte EP45-DS3L board

Anyone experiencing the same?? Any solution or advice?

Thanks
Mahony

Hi and welcome to the 1C forums.

There are some errors in your conf.ini.

Try this conf.ini first to see if it runs stable, then we can tweak more later :)

thanx for config. I have just tried it but after like 2mins the same... squares and then black. The worst is that there is no log nowhere so I don't know where to start troubleshooting.. :(
So what could be the next step?

found only this log with fresh date

Small squares? Are those in place of where the text should be? If that's the case then it's probably your ATI card. You should firstly run the game on "excellent" rather than "perfect" and then figure out which drivers you need to get the game running well in perfect mode. As I recall, the last diver that did that was 11.5.

I don't have an ATI card right now, but for a while I did have a computer which had one. It's too bad that Il-2 doesn't run well on them, but it should handle most other games just fine.

yep. squares.not in the text. it's like if the next frame draws over the previous but only on some squares spread over all the screen. like shifting the screen. game (sound) goes on I can hear the engine and my crash to the ground or whatever.

I don't run it on perfect. I have only vehicle detail on excellent and the rest even lower.

You mean that 11.5 was the last ok or it was the first with problems?
I have no problems in any other game/app at all.

just installed fresh new ATI drivers 11.10 and the same...

another try with 10.12 with the same result ... damn

IL2 1946 runs under OpenGL default, unless you have switched it to Dx.


Have you tried Driver Sweeper to clear out old ATI and Nvidia files and dll's

http://www.softpedia.com/dyn-postdow...101717&t=4&i=1
.

driver sweeper is discontinued.... my be i'll try to find something similar.
Tried to switch to OpenGL but with the same result with 10.12 and 11.10.

Is there a log somewhere in il2 directories?

Download it from here.

http://www.softpedia.com/dyn-postdow...101717&t=4&i=1

You need to clean up your system from old driver installations to make sure its clean.

Can you repost your conf.ini again from the IL2 directory, I want to see if anything changed after I altered the old one.