right wing keeps dipping down
 

Controler warthog
I have set up most of my controler, but for some reason in flight, the right wing wants to keep dipping down
any advice help?
regards
josh

Depending on the plane,you can set elevator,aileron and rudder trim in controls.
109 only has elevator trim,Spitfire has all three I think.

Ive done the aileron trim, and it re-levels , but it just keeps dipping down
and its hard work trying to keep it level lol

Its the summer of 1940,of course its hard work! ;)

ok will try a few other planes see if it still happens with them
Do you live on these forums, im surprised you can find time to fly JG52Uther:grin:

I spend more time talking about CoD than flying it,as I spend a lot of time working on a laptop :(

Well you no what they say m8, Its good to talk :)

To confirm it's a trim issue due to wind, use trim to get level in one direction and then bank 90 degrees and level off. You should have to re-trim.

Even better, do a 180 degree turn and see if it's banking the other way.

If it's trim due to engine torque or similar, you can try turning that off and seeing how level you fly.

If you suspect it's the controller, disconnect that and fly with keys and check behaviour.

I thought I had a problem, but after a lot of flying around in several different aircraft, I am fairly convinced it is due to the FM and that you need to trim a fair amount to maintain S&L flight. The banking I find is countered well enough on Brit fighters with a touch of rudder trim.

It could well be observer error, but I noticed that my trim changed when flying straight from over land to over sea and crossing a fair distance. I would also have to re-trim after banked turns like above.

What I would love confirmed is how complex a wind model (if at all thus rendering all my fiddling moot) is employed. Trying to use fliers' tricks like looking at the smoke from a burning wreck (I'd use domestic chimneys or power stations in rl) doesn't seem to help as it always goes straight up. Likewise, clouds do not seem to drift so no help there.

there are options for keys or axes to use for trimming plus options for up 1 notch down 1 notch or level .im a complete beginner in trimming so which do you use and do you have to do it all through the flying,also my ch fighterstick in IL2 the wheels on the base let you trim the aileron and nose etc but this doesnt seem to work on this 1, also the wheels when i try to assign say its the same axes for ailerons so no seperate function,didnt do that with il2?
thanks lot of questions i know lol

Wind really does not effect an aircraft in flight unless you get am abrupt change of direction of the wind. The aircraft is flying in a body of air which is moving, so the main effect is the track the aircraft takes over the ground.

The reason for lateral trimming of an aircraft is largely related to the gyroscopic effect of the prop. At high revs it will cause the tendency to slowly drop a wing. Too prove the point, try reducing prop RPM and manifold pressure to a slow cruise and you will find the rudder input required to maintain straight and level flight is reduced.

To solve this most pilots either hold a little rudder or preferably tweak the rudder trim. Bare in mind, every change of RPM/Man Pressure will require re-trimming the aircraft, Power, Attitude, Trim is handy to remember.

It's the way it works in the real world.