When building missions with the new Test Runway 5, it is possible to create a base (on very flat ground) with ground spawns - which is a big step forward.

Unfortunately, while in the aircraft taking off it looks like you are on the ground, but in external view you are on an invisible runway some feet above it.

This the case, when at one point or edge the runway object is on a small hill or such, and the whole runway object, staying 100% horizontal, is shifted upward by this. To prevent this, make sure its all 100% flat area (which hardly will be anywere else than water, small islands and near rivers).

Its no bug.

Loading (splash) screen in low-res color...
 

Not sure if this has been discussed already or not, but the load screen since 4.10 has appeared to be about 8bit color depth.. Worked fine in all version up to then.

Please make a screenshot of that! :-P

Sorry, was my mistake... not an issue with 4.101.

Ok, thanks!

I noticed that Bf-109F-4 get overheat very quickly. I was able to run at 105% throttle with fully open radiator without any overheat. And also i got some freezes after updating 4.101.

can't reset proppitch on my stick. In some cases I see the proppitch lever moving along with the throttle..

Red Tint on new runway - still appearing?
 

I have attached a grab of an airfield on the Palau/Online Map showing the 'red tint' still appearing. I have successfully installed 4101.

Thanks DFLion

Which map? That is a key factor... some maps are hotter than others.