Originally Posted by VO101_Tom (Post 352223)

Hi. I had problem with this, and yes, works in reverse. 0 is agile, 1 is sluggish. (I set it 0.3)

"Sensitivity. Sets the linearity of the control input, that is, defines
whether the controller input is directly mapped to controller output in a
straight line where input is equal to output, or whether the output is nonlinear
and smaller controller movements are mapped to a smaller output
than direct, and larger are mapped to greater control output.
To put it simply, linear input provides for more responsive controls, and
non-linear input is more precise and steady.
0 sensitivity is fully linear, and 100 is fully non-linear."
(clod manual page 44)